Castle Creations Phoenix-85 High Voltage ESC Brushless

This is the Castle Creations PHOENIX-85 High Voltage Electronic Speed Control.

For use with Brushless motors only.

Features:

• Extremely Low Resistance (.0015 Ohms)
• High rate adjustable switching
• Up to 85A max continuous current
• Dual Opto-Coupled (No BEC)
• Up to 36 cells or 12s Lithium Polymer - Maximum
• 16 cells or 3s Lithium Polymer - Minimum
• 10AWG wiring for motor and battery leads
• Aluminum heatsinks (anodized green)
• Dynamic braking ensures folding props fold promptly
• Runs motor in forward OR reverse
• Overtemp Motor Cutoff with Reset
• Safe "Power On" arming program ensures motor will not accidentally turn ON
• Low torque "soft start" prevents damage to fragile gearboxes
• Auto Shut Down when signal is lost or because radio interference

User Programmable Features:

• Low-voltage cutoff with Auto-LiPo detect as default.
• Over-current Protection
• Brake Type
• Throttle Range - fixed/self-adjusting/governor
• Timing Advance
• Cutoff Type
• Soft Start ramp up
• Switching Frequency

Includes:

• One PHOENIX-85 High Voltage speed control w/Universal connector.
• One set of instructions.
• One small "Castle Creations" decal.

Requires:

• Bullet-type motor connectors.

• Battery Connectors - depends which connector is used on battery.

Specifications:

• Speed control body length: 2.8" (71mm)
• Speed control body width: 1.6" (41mm)
• Speed control body thickness: 0.9" (23mm)
• Motor wire lead length: 5.0" (127mm)
• Battery wire lead length: 7.0" (178mm)
• Servo wire lead length: 12" (305mm)
• Continuous current: 85A
• Up to 36 cells or 12s Lithium Polymer: Maximum
• 16 cells or 3s Lithium Polymer: Minimum
• Wire size for motor and battery leads: 10AWG

Comments:

 This speed control does NOT feature BEC. You must use an alternate power source for your receiver and servos.