Go back to: Products > Radios
View Cart

Futaba 7CAP PCM Radio Systems (FUTJ71xx)

$299.99

Futaba 7CAP 7-Channel 72 MHz Tx with FP-R138DP PCM Rx and 4 S3151 Digital Servos

This is the Futaba 7CAP 7-Channel Computer Aircraft Radio with the R138DP PCM Receiver and four S3151 Digital Servos.

Features:

10-model memory and 6-character model naming

Same Dial n' Key programming found on Futaba's 9C systems

Basic menu for everyday sport flying, Advanced menu for more complicated routines

Heli and airplane control layouts in FM or PCM

Airplane Specific Features:

  • Flaperon
  • Flap Trim
  • Air Brake
  • Elevator to Flap
  • Flap to Elevator
  • V-Tail Mixing
  • Elevon Mixing
  • Aileron to Rudder
  • Snap
  • Mode Select feature
  • Fail Safe (in PCM mode only)
  • Adjustable throttle cut
  • Throttle curve normal (5 points)
  • Pitch curve normal (5 points)
  • Three programmable mixes
  • VR switch controls proportional 7th channel
  • EEPROM memory feature retains settings even when transmitter battery is disconnected or removed

Mode Select Feature: Dual Rates on 4 Channels, Triple rates available if using the 3 position switch, Full function trainer system, trainer cord not included, use FUTM4415 or FUTM4420.

One year limited warranty

Includes:

  • One Futaba 7CAP 7-Channel Aircraft Radio
  • Four S3151 Digital Servos, FUTM0310
  • R138DP FM receiver, FUTL0802, FUTL0803
  • 600mAh NT8S600B TX battery, FUTM1457
  • 600mAh NR-4RJ RX battery, FUTM1280
  • FBC-19B (4) Wall charger, FUTM1830
  • Servo accessory bag, frequency flag set, neck strap, on/off switch, and instruction manual

Requires: Charging batteries overnight before use

Specifications:

Transmitter:

  • Transmitting Frequency: 72 MHz band
  • Modulation: FM/PPM or PCM, switchable
  • Power Supply: 9.6V NT8S600B NiCd battery
  • Current Drain: 250 mA

FP-R138DP PCM Dual Conversion Receiver:

  • Receiving Frequency: 72 MHz band
  • Intermediate Frequency: 10.7 MHz & 455 kHz
  • Power Requirement: 4.8 - 6V NiCd battery
  • Current Drain: 16 mA
  • Size: 2.56" x 1.42" x 0.85" (65mm x 36mm x 21.5mm)
  • Weight: 1.42 oz (40.3g)

S3151 Standard Size Digital Servo:

  • Control System: Pulse width control, 1.52 ms neutral
  • Power Requirement: 4.8V
  • Output Torque: 43 oz/in (3.1kg-cm) at 4.8V
  • Operating Speed: 0.21 sec/60 at 4.8V
  • Size 1.59" x 0.79" x 1.42" (40.5mm x 20mm x 36.1mm)
  • Weight: 1.48 oz (42g)