Berg-5*DSP Receiver with Digital Signal Processing

This small, lightweight receiver is a full-range, no compromise, super narrow band receiver using Digital Signal Processing ("DSP") in the servo pulse decoder for optimum performance in even the worst RF environments.

By itself, this receiver weighs only 9.5 grams. It is packaged in a strong, lightweight, fuel-proof, case (3.5 grams). It is available in servo pins Up (vertical pins) and servo pins Out (horizontal pins) configurations.

To save weight, some people take this receiver out of its case and protect it with thin heat-shrink material. To facilitate this, we have designed a special antenna restraint into this receiver. This does not mean that you can "pull all you want" on the antenna, but it is a vast improvement over what we have thus far seen in the industry.

Note: Futaba Radios with Frequency Synthesizers are not compatible with these receivers.

Berg-5*DSP Receiver with Vertical Pins and Free Berg Crystal          $49.95 [On Order]

Berg-5*DSP Receiver with Horizontal Pins and Free Berg Crystal      $49.95 [On Order]

• Narrow band: 7 KHz or better
• Weight (receiver with crystal): 9.5 grams
• Weight (case): 3.5 grams
• Dimensions: See drawings
• Operating voltage: 3.6 ~ 6.0 Volt*
• Operating range: Line-of-sight
• Crystal: Berg, JR, or GWS Single Conversion
• Shift polarity: Switch selectable for either negative shift (Futaba/Hitec), or positive shift (JR/Airtronics)
• Output channels: 1, 2, 3, 4, and 6

• Receiver will operate with full range on a 3-cell Ni-Cd pack, thus allowing for single-cell failure. It should be noted that the servo response will become [much] slower when operated under these conditions.
• Receiver is reverse-voltage protected; this means that accidental reversal of battery voltage will not destroy it.